Table of Contents
Advertisement
OPERATING THE FORKLIFT
Transporting Loads
Loading
1.
Load on the ground:
(1) Drive the forklift carefully up to the load and brake the forklift to a stop.
(2) Tilt the mast forward and place the forks on the floor.
(3) Insert the forks under the load.
(4) Raise the forks above the ground and tilt the mast backwards.
(5) When transporting, drive with caution, pay attention to the route condition and to
the people ahead and maintain a proper driving speed. Transport the load to the
designated place.
2.
Load on the high shelf:
(1) Drive the forklift carefully up to the load and brake the forklift to a stop.
(2) Set the mast in the vertical position and raise the forks to the bottom of the load.
(3) Insert the forks under the load.
(4) Raise the load until it has left the shelf completely.
(5) Set the driving direction to reverse and release the brake.
(6) Reverse the forklift with caution at a low speed until the forklift leaves the stacking
area.
(7) Lower the forks to above the floor and tilt the mast backwards.
(8) When transporting, drive with caution, pay attention to the route condition and to
the people ahead and maintain a proper driving speed. Transport the load to the
designated place.
Travelling
1.
When travelling with load, make sure that the load is well centered on the forks.
2.
After the load is placed on the forks, keep the mast tilted backwards and raise the forks
above the floor.
3.
During the travelling of the forklift, do not tilt the mast forward or try raising the forks to
avoid the danger of forklift nose over and losing stability.
4.
If the stacked loads are high and affect the operator's visibility of the route ahead,
operate the forklift in reverse except when the forklift is climbing the slope or inclines.
OPERATOR MANUAL
https://www.forkliftpdfmanuals.com/
66
Advertisement
Table of Contents
