Advertisement
Definitions
All Code Lockout Mode: This feature is enabled by the Master code. When enabled, it restricts all user (except
Master)
PIN
code access. When attempting to enter a code while the unit is in Lockout, the
appear on the screen.
Automatic Re-lock Time: After a successful unlock, the unit will re-lock automatically after duration selected in the
Advanced Lock Settings (Main Menu selection #3).
Handing the Lock: Lock handing refers to which direction the bolt comes out of the door (right or left). If the lock
was programmed off the door, the lock may need adjusting. Review Handing the Lock instructions and/or Re-
Handing instructions listed in Hardware Troubleshooting.
Inside Indicator Light: Located on the interior lock. Shows active status (Locked) of lock and can be enabled or
disabled in the
Advanced Lock Settings
Language Setting Mode: Choosing English (1), Spanish (2) or French (3) becomes the (default) setting for the
lock's voice prompts.
Low Battery: When battery power is low, the Low Battery Warning indicator flashes
completely lost, use the cylinder key override.
Master
PIN
Code:
The Master
to programming the lock. The Master code will also operate (unlock/lock) the lock.
Network Module Setting: With the optional Network Module installed, this setting becomes available thru the Main
Menu (7) and allows the lock to connect with a network controller.
One Touch Locking: When the latch is retracted, activating the keypad will extend the latch (during Automatic Re-
lock duration or when Automatic Re-lock is disabled). When One-Touch Re-lock is
PIN code will re-lock the lock.
Previous: While in Menu Mode, pressing this icon cancels the current operation and returns the user to the
previous step.
Privacy Mode: Privacy mode is disabled by default. Enable Privacy Mode by pressing the privacy button for 4
seconds to put the lock in do-not-disturb mode (all pin codes are disabled).
Shutdown Time: The unit will shutdown (flashing
wrong code entry limit (5 attempts) has been met.
Tamper Alert: Audible alarm sounds if attempting to forcibly remove outside lock from door.
User
PIN
Code:
The User code operates the lock. Maximum number of user codes with Z-Wave Plus or ZigBee
network module is 250; without network module or with iM1 network module, maximum is 25; with Bluetooth,
maximum is 12. Note: When deleting user pin code(s), screen will display user pin code being deleted.
Volume Setting Mode:
The volume setting for
set to
High (1)
or
Silent (3)
Wrong Code Entry Limit: After five (5) unsuccessful attempts at entering a valid
and not allow operation for sixty (60) seconds.
(Main Menu selection #3).
PIN
code is used for programming and for feature settings.
RED
PIN
code verification is set to
for quiet areas.
P/N
YRL EMICL TSINSTL FUL
-
) for sixty (60) seconds and not allow operation after the
Low (2)
32
-
-
Rev G
RED
locked padlock will
RED
. If battery power is
It must be created prior
not
in use
(disabled),
any valid
by default; otherwise it can be
PIN
code, the unit will shut down
Advertisement
