Advertisement
Changing Lock: Replacing Cylinder
To remove cylinder:
A. Remove touchscreen from door.
B. Remove pan head screw.
C. Remove cylinder by letting it drop out of assembly.
Touchscreen shown
A
removed from door.
Resetting Lock to Factory Default
When resetting the lock, all user codes, including the
Master
PIN
code*, are deleted. All programming features
are reset to original default settings (see below).
1. Remove the battery cover and batteries.
2. Remove the interior lock to access the reset button hole.
(See image at right.)
3. Re-insert 3 batteries and insert a small screwdriver into
the hole; holding the reset button for 3 seconds.
4. While still holding the reset button, insert the 4th battery
and hold the reset button for an additional 3 seconds.
5. Release the reset button.
6. Re-install the interior lock onto the door.
Upon reset, Master PIN Code creation is the only option
available and must be performed prior to any other
programming of the lock.
Please use this procedure only when network primary
controller is missing or otherwise inoperable.
For best results, the lock should be installed on the door when
resetting the lock to factory default. If the process was done
and the lock was not installed on the door, review the Re-
Handing instructions listed in Hardware Troubleshooting.
C
B
27
P/N
YRL EMICL TSINSTL FUL
-
-
-
Interior Lock
(4" Shown)
Rev G
Advertisement
