Replacing A Celeron Processor (Ba400 Pcs) - HP Brio BA400 User Manual

Replacing a Celeron Processor (BA400 PCs)

Replacing a Celeron Processor (BA400 PCs)

Caution For your safety, disconnect the power cord and all external cables.
1 Remove the cover. Refer to page 44.
2 Open the side panel of the PC and lay the system board flat. Refer to "Removing the
Side Panel for Easy Access to System Board Components" on page 46.
3 Unclip and remove the heatsink.
Note Some Celeron processors may use a slightly different design of heatsink.
4 Raise the lever to the side of the socket to release the old processor, then lift it out.
5 Install the new processor in the socket, with its corner marker facing the corner
marker on the socket, then lower the lever to lock it in place.
6 Replace the heatsink and fasten the retention clip.
7 Refer to page 48 for instructions on reinstalling the system board in your PC.
8 Replace the PC's cover. Refer to page 45.
50