Table of Contents
Advertisement
A Regulatory compliance and
safety
Regulatory compliance
Federal Communications Commission notice for Class A equipment
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense. The end user of this product should be aware
that any changes or modifications made to this equipment without the approval of Hewlett-Packard
could result in the product not meeting the Class A limits, in which case the FCC could void the user's
authority to operate the equipment.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by Hewlett-Packard Company my void the user's authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods
in order to maintain compliance with FCC Rules and Regulations.
Regulatory compliance identification numbers
For the purpose of regulatory compliance certifications and identification, your product has been
assigned a unique Regulatory Model Number. The RMN can be found on the product nameplate label,
along with all required approval markings and information. When requesting compliance information for
this product, always refer to this RMN. The Regulatory Model Number should not be confused with the
marketing name or model number of the product.
Laser device compliance
The fiber optic transceiver contains a laser that is classified as a "Class 1 Laser Product" in accordance
with US FDA regulations and the IEC 60825-1. The product does not emit hazardous laser radiation.
This laser product complies with 21 CFR 1040.10 and 1040.1 1 except for editions pursuant to Laser
Notice No. 50, dated May 27, 2001; and with IEC 60825-1:1993/A2:2001.
Brocade 8Gb SAN Switch for HP BladeSystem c-Class
41
Advertisement
Table of Contents
