Table of Contents
Advertisement
Figure 5 Installing the Brocade 8Gb SAN Switch into an interconnect bay
5.
Press the installation handle into the latch to lock the Brocade 8Gb SAN Switch in place.
CAUTION:
All panels and doors should be in place and securely fastened while the unit is in operation, for proper
cooling and for EMI emissions control.
OA power verification
As defined earlier, the HP BladeSystem Onboard Administrator (OA) is the enclosure management
processor that manages the devices contained within the enclosure. The OA provides a single point from
which to perform basic management tasks on switches or server blades installed in the enclosure.
IMPORTANT:
HP recommends reading the appropriate
Onboard Administrator User Guide
of your specific enclosure model.
Once the switch is installed in the interconnect bay, the OA verifies that the switch type matches the
mezzanine cards present on the servers. If there is no mismatch, the OA powers up the switch.
If the switch does not power up, check the enclosure and switch status with the OA web interface. Refer to
the HP BladeSystem Onboard Administrator User Guide.
Check LEDs
See
Figure 6
to locate power-on LEDs. Verify that the LEDs match the indicators described in
22
Setup
HP BladeSystem Enclosure User Guide
. Reading these guides in sequence will promote an overall understanding
26481a
HP BladeSystem
and the
Table
10.
Advertisement
Table of Contents
