Modifying The Fc Domain Id (Optional); Disabling And Enabling A Switch - HP StorageWorks T5527A User Manual

nl
switch:admin> licenseshow
nl
nl
XXXnnXXnXnnXXX:
nl
nl
Fabric Watch license
nl
nl
Release v5.0 license
nl
nl
XXXnnXXnXnnXXX:
nl
nl
Zoning license
nl
nl
XXXnnXXnXnnXXX:
nl
nl
Web license
nl
nl
XXXnnXXnXnnXXX:
nl
nl
Full Fabric
NOTE:
For more information about the CLI, refer to the latest version of the

Modifying the FC domain ID (optional)

If desired, you can modify the FC domain ID. The default FC domain ID is domain 1. If the 8Gb SAN
Switch is not powered on until after it is connected to the fabric, and the default FC domain ID is already in
use, the domain ID for the new switch is automatically reset to a unique value. If the switch is connected to
the fabric after is has been powered on and the default domain ID is already in use, the fabric segments.
Enter fabricshow to determine the domain IDs that are currently in use. The maximum number of
domains with which the 8Gb SAN Switch communicates is determined by this switch's fabric license.
To modify the domain ID:
1.
Enter switchdisable to disable the switch.
2.
Enter configure, and then enter a new value.
Or press Enter to accept each default value.
3.
At the Fabric parameters prompt, enter Y and press Enter:
Fabric parameters (yes, y, no, n): [no] y
4.
Enter a unique domain ID. For example:
Domain:
5.
Complete the remaining prompts, or press Ctrl+D to accept the remaining default settings.
6.
Enter switchenable to re-enable the switch.
7.
Enter fabricshow to confirm any changes made to the domain ID.
8.
Optionally, verify switch policy settings, and specify any custom status policies that need to change:
a. Enter switchstatuspolicyshow to verify the current policy settings. If desired, enter
switchstatuspolicyset at the prompt to change switch policy settings. This command sets
the policy parameters that determine the overall switch status.
b. Customize the status policies as desired.
9.
To deactivate the alarm for a particular condition, enter 0 at the prompt for that condition.

Disabling and enabling a switch

By default, the switch is enabled after power on and after the diagnostics and switch initialization routines
complete. You can disable and re-enable the switch as necessary.
To disable:
(1..239) [1] 3
Fabric OS command reference guide
Brocade 8Gb SAN Switch for HP BladeSystem c-Class
.
27