Configuring The Uplink Vlan - HP ProCurve J8162A Supplementary Manual

Configuring the Access Controller xl Module

Configuring the Uplink VLAN

To change the uplink VLAN, make the internal uplink port an untagged member
of a new VLAN. Be sure that the new VLAN allows communication with the
740wl/760wl, or communications is lost.
HPswitch (Config)# vlan 25 untagged <slot-id>up
where slot-id is the 5300xl switch slot where the ACM module is installed.
This command configures a new uplink VLAN, VID 25, for the ACM module
installed in slot n.
19