HP ProCurve J8162A Supplementary Manual page 19

HPswitch (config)# access-controller <slot-id>
where <slot-id> is the slot in the 5300xl where the ACM is installed.
HPswitch (access-controller-id)# ip address <<ip-addr>/<1-32> |<ip-addr> <mask>>
where <ip-addr>/<1...32> is the selected address in CIDR notation (/mask
bit number), for example 10.1.2.3/24.
<ip-addr> <mask> provides the selected address and the mask.
If necessary, use the following command to set or change the default gateway:
HPswitch (access-controller-id)# ip default-gateway <ip-addr>
where <ip-addr> is the numeric IP address of the default gateway, for
example 10.1.2.3.
Use the IP address of the 740wl/760wl and its shared secret to establish
communications with the ACM.
HPswitch (access-controller-id)# access-control-server ip <ip-addr> secret
<secret> <secret>
where <ip-addr> is the address of the 740wl/760wl
<secret> is the shared secret configured on the 740wl/760wl.
In the following example, an ACM establishes communications with an access
control server with IP address 13.13.13.8. The access control server has a
shared secret of 7734Oh. The show status command is used to confirm that
communications has been established, indicated by a time value displayed
(2 secs) in the Connected: field.
Configuring the ACM on the Network
15