Table of Contents
Advertisement
The Connection/Power Menu
The Connection/Power menu is used for setting for the connections and power.
Setting items
Network Setting
IPv4 Setting
IP Address Setup
IP Address/ Subnet
Mask/ Default
Gateway/Primary
DNS/Secondary
DNS
IPv6 Information
HDBaseT Settings
LAN Setting
RS-232C Setting
*3
Dynamic Range
Input-A Signal Sel.
Color System
ECO
Light Output Mode
Constant
*5
Brightness
Description
Auto (DHCP): The IP address is assigned automatically from the
DHCP server such as a router.
Manual: To specify the IP Address manually.
When "Manual" is selected for "IP Address Setup," select the item
with the B or b key and input the value with V or v key. When all
items are entered, select "Apply" then press the ENTER key. The
entered settings will be registered.
Displays the IPv6 address information.
When setting the address of IPv6, set it from the browser.
via HDBaseT/LAN: You can select either via the LAN
HDBaseT equipment connected to the Digital Interface Adaptor
BKM-PJ10 or via the network connection with the LAN terminal of
the main unit.
via HDBaseT/RS-232C: You can select either via the RS-232C
the Digital Interface Adaptor BKM-PJ10 or via the connection with
the RS-232C terminal of the main unit.
Sets the image input level of the INPUT C/D/E terminal.
Auto: Distinguishes the image input level automatically.
Limited: Set when the image input level is 16-235.
Full: Set when the image input level is 0-255.
Auto/Computer/Video GBR/Component: When set to "Auto,"
selects the type of video signal input automatically when "Input-A" is
selected with the INPUT key.
Auto/NTSC
/PAL/SECAM/NTSC
3.58
to "Auto," selects the color system automatically when "S-Video" or
"Video" is selected with the INPUT key.
High/Standard/Auto/Custom/Extended: When set to "High," the
image becomes brighter, and power consumption becomes higher.
When set to "Standard," power consumption becomes lower; however,
the image will be darker. When set to "Auto," brightness is adjusted
automatically according to image content. Dark images are projected
with brightness adjusted, leading to energy-saving. Bright images are
projected brightly, without adjusting brightness. When set to
"Custom," you can adjust brightness as prefer. If you select
"Extended," images become dark but extended projection is enabled.
On/Off: Available when Light Output Mode is set to "High" or
"Standard." Brightness is constant at about 75% light output when
Light Output Mode is set to "High," and at about 60% when Light
Output Mode is set to "Standard."
*4
/PAL-M/PAL-N: When set
4.43
*4
The Connection/Power Menu
*1
of the
*2
of
29
Advertisement
Table of Contents
