Table of Contents
Advertisement
The Connection/Power Menu
The Connection/Power menu is used for setting for the connections and power.
Setting items
Network Setting
*1
IPv4 Setting
IP Address Setup
IP Address/ Subnet
Mask/ Default
Gateway/Primary
DNS/Secondary
DNS
IPv6 Information
HDBaseT Settings
LAN Setting
RS-232C Setting
*5
Dynamic Range
HDMI Cable
Input-A Signal Sel.
Color System
ECO
Auto Power Saving
With No Input
Description
Auto(DHCP): The IP address is assigned automatically from the
DHCP server such as a router.
Manual: To specify the IP Address manually.
When "Manual" is selected for "IP Address Setup," select the item
with the B or b key and input the value with V or v key. When all
items are entered, select "Apply" then press the ENTER key. The
entered settings will be registered.
Displays the IPv6 address information.
When setting the address of IPv6, set it from the browser (page 44).
via HDBaseT/LAN Port: You can select either via the LAN of the
HDBaseT equipment connected to the HDBaseT teminal or via the
network connection with the LAN terminal of the main unit.
*4
via HDBaseT: You can connect this unit to the RS-232C terminal via
the HDBaseT transmitter. (Baud rate: 9,600 bps)
RS-232C: Use when connecting to the RS-232C terminal of this unit
directly.
Sets the image input level of the INPUT B/C/D terminal.
Auto: Distinguishes the image input level automatically.
Limited: Set when the image input level is 16-235.
Full: Set when the image input level is 0-255.
Long/Normal: Select "Long" when the image is disturbed or not
projected.
Auto/Computer/Video GBR/Component: When set to "Auto,"
selects the type of video signal input automatically when "Input-A" is
selected with the INPUT key.
Auto/NTSC
/PAL/SECAM/NTSC
3.58
to "Auto," selects the color system automatically when "Video" is
selected with the INPUT key.
Light Cutoff: The light turns off automatically and power
consumption is reduced if no signal is input for about two minutes.
The light turns on again when a signal is input or any key is pressed. In
Light Cutoff, the ON/STANDBY indicator lights in orange. (page 49)
*7
Standby
: If no signal is input to the unit for about two minutes, the
power turns off automatically, and the unit enters standby mode.
Off: The "With No Input" function is disabled.
*6
/PAL-M/PAL-N: When set
4.43
*6
34
*2 *3
Advertisement
Table of Contents
