Table of Contents
Advertisement
Dimming
Standby Mode: Low
(go to step 6)
User: Sets each item of the energy-
saving mode menu as you desire
(go to step 3).
3 Select "User" then press the b key.
The setting items appear.
User
Light Output Mode
Constant Brightness
Auto Power Saving
With No Input
With Static Signal Light Dimming
Standby Mode
Sel
Set
4 Press the V/v key to select the ECO
Mode item then press the b key or the
ENTER key.
5 Press the V/v key to select the setting
value.
6 Press the RETURN key to restore the
previous image.
For details on ECO Mode settings, see
"Light Output Mode", "With No Input",
"With Static Signal" and "Standby
Mode" on the Connection/Power menu
(page 29).
Others
g Infrared transmitter
h ID MODE 1/2/3/4 switch
(page 28)
Sets an ID mode of the Remote
Commander. If you assign a different ID
number to each projector when multiple
projectors are used, you can control only
the projector with the same ID mode as
that of the Remote Commander.
i CONTROL S output terminal
Connects to the CONTROL S input
terminal on the projector with a
connecting cable (stereo mini plug (not
supplied)) when using the Remote
Commander as a wired one.
You do not need to install batteries in the
Remote Commander, as the power is
supplied from the projector.
Standard
Off
Off
Standard
Back
About Remote Commander operation
• Direct the Remote Commander toward the
remote control receiver.
• The shorter the distance between the
Remote Commander and the projector is,
the wider the angle within which the
Remote Commander can control the
projector becomes.
• If there is any obstruction between the
Remote Commander and the remote
control receiver on the projector, the
projector may not be able to receive
signals from the Remote Commander.
Location and Function of Controls
7
Advertisement
Table of Contents
