The Connection/Power Menu - Sony VPL-DX270N Operating Instructions Manual

Table of Contents

Advertisement

The Connection/Power Menu

The Connection/Power menu is used for setting for the connections and power.
Items
ECO
Lamp Mode
Power Supply
Auto Power Saving
With No Input
With Static
Signal
*1
Input-A Signal Sel.
Direct Power On
Cooling Time
Notes
*1: This may not be optimum depending on the input signal. In this case, set manually according to
the connected equipment.
Item descriptions
High/Standard/Low/Auto
brighter, and power consumption becomes higher. When set to "Low,"
power consumption is minimized; however, the image will be darker.
When set to "Auto," brightness is adjusted automatically according to
image content. Dark images are projected with brightness adjusted,
leading to energy-saving. Bright images are projected brightly, without
adjusting brightness.
Off/On: When set to "On," the unit supplies power to the external
device (stick type PC, etc.) through the USB cable. For power supply,
see "Supplying the power to the external device" (page 16).
Auto: The lamp turns off automatically and power consumption is
reduced if no signal is input for more than about 10 minutes.
The lamp lights again when a signal is input or any key is pressed. After
the lamp turns off, the ON/STANDBY indicator lights in orange
(page 34).
*2
Standby
: If no signal is input to the unit for more than about 10
minutes, the power turns off automatically, and the unit enters standby
mode.
Off: You can deactivate the With No Input.
*4*5
Lamp Dimming
: If an image does not change for about
10 seconds, lamp output is gradually reduced (approximately 10% to
*3
15%
) from that set in the Lamp Mode. Automatically the lamp slowly
darkens to approximately 30% of its lamp output according to the
selected time (with no change to input signal) "5," "10," "15," "20"
minutes or "Demo.," While dimming the lamp, the message "Lamp
Dimming" appears. If you select "Demo.," the image will start to
darken about 40 seconds later. When any change in signal is detected,
or an operation (remote control or control panel) is performed, normal
brightness is restored.
Off: You can deactivate the With Static Signal.
Auto/Computer/Component/Video GBR: When set to "Auto," selects
the type of video signal input automatically when "Input-A" is selected.
On/Off: When set to "On," you can turn the power on without going to
Standby mode when the AC power cord is connected to a wall outlet.
With the projector turned off, you can also unplug the AC power cord
without going to Standby mode, regardless of the Direct Power On
setting.
Standard/Quick: Sets the duration of unit cooling after turning off the
lamp. If set to "Standard," the temperature of the unit will be cooled
enough to be carried.
*5
: When set to "High," the image becomes
The Connection/Power Menu
*6
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vpl-dx240nVpl-dx220n

Table of Contents