Table of Contents
Advertisement
Setting items
*10
Color Matching
Notes
*1: You cannot adjust anything other than the targeted adjustment zones in "Zone Black Level Adj."
*2: When selecting the correction zone of "Zone Black Level Adj.," the targeted correction zone
flashes twice.
*3: If the Screen Aspect is set to 16:10 and input signal is 16:10 or 16:9, the image will be projected
at the correct aspect. This function is not available when displaying two pictures.
*4: When "Edge Blending" is set to "On," "Screen Fitting" (HV Keystone/Warping) is not
displayed.
*5: Depending on the position adjusted with the lens shift feature, the aspect ratio of the image may
change from the original or projected image may be distorted with Keystone adjustment.
*6: Since the HV Keystone/Warping adjustment is an electronic correction, the image may
deteriorate.
*7: Select "Link to Image Flip" only for horizontal installation. Be sure to select "Front Down" or
"Front Up" for a vertical installation, or "Portrait 1" or "Portrait 2" for a portrait installation, to
match the installation direction of the projector. (Refer to the figures.)
*8: In the case of a portrait installation, pay attention not to block the ventilation holes (exhaust/
intake).
*9: Depending on the adjustment value of "Panel Alignment," the color and resolution may be
changed.
*10:The brightness and color of the projected image may not match completely, even after you adjust
"Brightness" and "Color."
34
The Installation Menu
Description
Adjust/Reset: For correcting the brightness and color of the whole
projected image manually from the signal level in six steps.
Advertisement
Table of Contents
