Table of Contents
Advertisement
The Connection/Power Menu
The Connection/Power menu is used for setting for the connections and power.
Items
LAN Settings
IP Address
*1
Setup
WLAN Settings
WLAN
*2
Connection
WLAN
*3
Network
HDBaseT setting
HDBaseT/LAN
terminal
RS-232C setting
Network Presentation
Connection
CODE
Display Setting
*6
Dynamic Range
Item descriptions
Auto (DHCP): The IP address is assigned automatically from the
DHCP server such as a router.
Manual: To specify the IP Address manually.
On/Off: Set the wireless output of the USB wireless LAN module (not
supplied) to On/Off.
*4
Access Pt./Client
: Changes modes for WLAN.
Sets the function of the HDBaseT/LAN terminal. (VPL-EW578 only)
HDBaseT: Connecting the HDBaseT transmitter and the LAN cable
enables transmitting the signal of the Video, Audio, Ethernet, and
RS-232C.
LAN: Connecting the LAN cable for Ethernet directly enables
connecting to the network.
(Use when connecting the cable directly without the HDBaseT
transmitter.)
Via HDBaseT: You can connect this unit to the RS-232C terminal via
the HDBaseT transmitter. (Baud rate: 9600bps)
RS-232C terminal: Use when connecting to the RS-232C terminal of
this unit directly.
On/Off: This is the presentation function via the network. It controls
the connection using the displayed number (CODE) on the right bottom
of the screen. During the image transmission, using the ENTER key on
the remote commander makes Connection CODE display again.
LAN Mode
Displays the LAN settings of the projector or the
settings of the USB wireless LAN module that operates
as a client at the bottom right of the screen.
Wired: Displays the IP address of LAN preferentially.
Wireless: Displays the IP address of the USB wireless
LAN module preferentially.
AP Mode
Displays the SSID of the USB wireless LAN module
that operates as an access point at the bottom right of the
screen.
Sets the image input level of the INPUT C/D/E terminal.
Auto: Distinguishes the image input level automatically.
Limited: Set when the image input level is 16-235.
Full: Set when the image input level is 0-255.
*5
*7
The Connection/Power Menu
31
Advertisement
Table of Contents
