Front Of The Switches; Network Ports - HP J3175A Installation And Reference Manual

Hewlett-packard advancestack switch installation and reference guide
Table of Contents

Advertisement

Switch 208/224 Description

Front of the Switches

Front of the Switches
Power
Fault
LED
LED
HP J3175A
Switch 208T
HP J3177A
Switch 224T
Switch Management Module

Network Ports

All the twisted-pair ports are wired as MDI-X. Therefore, to connect end nodes
or other MDI-type devices to these ports, use "straight-through" twisted-pair
cable; to connect hubs, switches, or other MDI-X-type devices to these ports,
use "crossover" twisted-pair cable. See appendix A, "Cables and Connectors"
for descriptions of these cables.
The cabling to the transceiver port depends on the type of transceiver
installed. For more information, refer to the manual that came with the
transceiver.
2-2
4 LEDs for
expansion module
RPS
LEDs for
LED
100 Mbit/s ports
100 Mbit/s ports:
slot for
- one fixed RJ-45
- one
8 or 24 10 Mbit/s RJ-45 Ethernet/IEEE 802.3 ports
one fixed 100 Mbit/s RJ-45 100Base-TX port
one 100 Mbit/s transceiver slot for installing HP 100Base-TX or 100Base-
FX transceivers
LED indicating
Port 1 is disabled
LEDs for
10 Mbit/s ports
10 Mbit/s RJ-45ports

Advertisement

Table of Contents
loading

This manual is also suitable for:

J3177aAdvancestack 208Advancestack 224Advancestack switch 208Advancestack switch 224J3175a

Table of Contents