Connect The Switch To A Power Source - HP ProCurve 2124 Install Manual

Installing the Switch 2124
Installation Procedures
Horizontal Surface Mounting
Place the switch on a table or other horizontal surface. The switch comes with
rubber feet in the accessory kit that can be used to help keep the switch from
sliding on the surface. Attach the rubber feet to the four corners on the bottom
of the switch within the embossed angled lines. Use a sturdy surface in an
uncluttered area. You may want to secure the networking cables and switch
power cord to the table leg or other part of the surface structure to help
prevent tripping over the cords.
N o t e
Make sure the air flow is not restricted around the sides and back of the switch.

5. Connect the Switch to a Power Source

1.
2.
2-12
Plug the included power cord into the switch's power connector and into
a nearby AC power source.
Re-check the LEDs during self test. See "LED Behavior" on page 2-7.