Removing The Transceiver; Connect The Switch To A Power Source - HP Aruba 3810M Series Installation And Getting Started Manual

seconds, with the worst case being 5 seconds. If the transceiver is removed before the
authentication completes a self test failure will be reported.
WARNING!
direct eye exposure to the beam coming from the transmit port.
Figure 22 Installing a transceiver

Removing the transceiver:

NOTE: Always disconnect the network cable from the transceiver before removing it from the
switch.
Depending on when the transceiver was purchased, it may have either of three different release
mechanisms: a plastic tab on the bottom of the transceiver, a plastic collar around the transceiver,
or a wire bail.
To remove the transceivers that have the plastic tab or plastic collar, push the tab or collar toward
the switch until the transceiver releases from the switch (it will move outward slightly), then pull
it from the slot.
To remove the transceivers that have the wire bail, lower the bail until it is approximately horizontal,
and then using the bail, pull the transceiver from the slot.

8. Connect the Switch to a Power Source

1. Plug the included power cord into the switch's power connector and into a nearby AC power
source.
2. Re-check the LEDs during self test. See "LED Behavior" on
42 Installing the Switch
The Hewlett Packard Enterprise transceivers are Class 1 laser devices. Avoid
LED Behavior:.