HP ProCurve 2124 Install Manual page 41
Hp procurve 2124: install guide
Hide thumbs
Also See for ProCurve 2124:
- Product overview (4 pages) ,
- Supplementary manual (2 pages) ,
- Brochure & specs (5 pages)
Table of Contents
Advertisement
Other Wiring Rules:
All twisted-pair wires used for 10 Mbps, and 100 Mbps operation must be
I
twisted through the entire length of the cable. The wiring sequence must
conform to EIA/TIA 568-B (not USOC). See the Pin Assignment tables
below the cable illustrations later in this appendix for a listing of the
signals used on each pin.
I
For 10 Mbps connections to the ports, you can use 100-ohm differential
Category 3, 4, or 5 unshielded (UTP) or shielded (STP) twisted-pair cable,
as supported by the IEEE 802.3 10Base-T standard.
I
For 100 Mbps connections to the ports, use 100-ohm differential Category
5 UTP or STP cable only, as supported by the IEEE 802.3u 100Base-TX
standard.
Switch Ports and Network Cables
Twisted-Pair Cable/Connector Pin-Outs
B-3
Hide quick links:
Advertisement
Table of Contents
