Advertisement
Basic Operations
Turning On or Off the Repeater
If the repeater is connected to a DC power supply, press
●
the power switch on the DC power supply to turn on or
off the repeater.
After turn-on, if the power supply indicator turns red,
the repeater goes into locked status. You must switch off
the DC power supply for four seconds, and then switch
on the power supply again.
●
If the repeater is connected to an AC power supply, press
the AC Power Switch in the rear panel to turn on or off
the repeater.
After turn-on, the power supply indicator turns yellow.
Changing the Channel
Press the Volume/Channel + or Volume/Channel – key to
change the channel.
The current channel number appears on the display of the
repeater.
Adjusting the Volume
1.
Long press the Volume/Channel + key for five seconds
to switch the repeater from channel mode to volume
mode.
2.
Press the Volume/Channel + or Volume/Channel – key
to increase or decrease the volume.
If you do not have any operation for greater than f ive
seconds or if you long press the Volume/Channel + key
again within five seconds, the repeater switches to channel
mode.
Checking the Status
Repeater
Indicator Description
Repeater Status
Digital
The repeater is operating in
Blue
Mode
digital mode.
Analog
The repeater is operating in
Yellow
Mode
analog mode.
The repeater is not working
Alarm
Red
properly, and the display
shows the alarm code.
●
Analog mode: The
repeater is transmitting.
Timeslot A
Red
●
Digital mode: The
TX
repeater is transmitting
on timeslot A.
●
Analog mode: The
repeater is receiving.
Timeslot A
Green
●
Digital mode: The
RX
repeater is receiving on
timeslot A.
Timeslot B
Digital mode: The repeater is
Red
TX
transmitting on timeslot B.
Timeslot B
Digital mode: The repeater is
Green
RX
receiving on timeslot B.
Network Interface
Indicator
Description
LED 1
Flashing
Ethernet
Interface
Glowing
LED 2
Off
Power Supply
Indicator
Power Supply
(Visible through
the Air Inlet for
Power Supply)
For details on more features and operations, please visit our
website at: http://www.hytera.com, or scan the QR code to
download the User Manual.
Repeater Status
The network interface
card is transmitting
data.
The data transmission
rate is 1000 Mbps/100
Mbps.
The data transmission
rate is 10 Mbps.
Description
Repeater Status
The repeater is supplied
Yellow
by an AC power.
The repeater is supplied
Blue
by a DC power.
The repeater cannot be
Red
turned on.
3
Advertisement
