Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hytera HR106X
Summary of Contents for Hytera HR106X
- Page 1 QUICK REFERENCE GUIDE HR106X DIGITAL REPEATER Hytera Communications Corporation Limited. 2020 Hytera Communications Corporation Limited. Address: Hytera Tower,Hi-Tech Industrial Park North,9108#Beihuan Road, 06073207 190335437 Nanshan District,Shenzhen,People’s Republic of China 5202010062391A...
-
Page 2: Product Overview
Product Overview Advanced Version Front Panel Blade Repeater SLOTA SLOTB ALARM Part Name Part Name TX Antenna Connector USB Connector Monitor/Tuning Interface DC Power Inlet Part Name Part Name Accessory Connector AC Power Inlet Air Inlet for PA Timeslot A RX Indicator RX Antenna Connector AC Power Switch Volume/Channel + Key... -
Page 3: Installation
Internal Parts ● AC power voltage: 100–240 V Part Name Part Name Installation Procedure Basic Version PA Module Wind Scooper To install the repeater, do as follows: Main Board Wear the anti-static gloves. Coprocessor Control Panel Place the repeater to a proper location. NOTE Power Supply Module Float Charging Board... -
Page 4: Basic Operations
For details on more features and operations, please visit our on the power supply again. Alarm properly, and the display website at: http://www.hytera.com, or scan the QR code to ● If the repeater is connected to an AC power supply, press shows the alarm code. - Page 5 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
-
Page 6: Fcc Radiation Exposure Statement
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an occupational/controlled environment. This transmitter must not be co‐located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with minimum distance 200cm between the radiator &you body. - Page 7 RF Exposure Compliance and Control Guidelines and Operating Instructions To control your exposure and ensure compliance with the occupational/controlled environmental exposure limits, always adhere to the following procedures. Guidelines: Do not remove the RF Exposure Label from the device. User awareness instructions should accompany device when transferred to other users. Do not use this device if the operational requirementsdescribed herein are not met.
Need help?
Do you have a question about the HR106X and is the answer not in the manual?
Questions and answers