Advertisement
Internal Parts
Basic Version
No.
Part Name
No.
1
PA Module
5
2
Main Board
6
3
Network Board
7
4
Power Supply Module
8
Advanced Version
No.
1
PA Module
2
Main Board
3
Coprocessor
4
Power Supply Module
Installation
To ensure optimum performance and reliability of the
repeater, read the following instructions carefully.
Installation Requirements
Environmental Conditions
The repeater must be installed in a dry and well-ventilated
Part Name
place. The operating temperature ranges from –30°C to
+60°C, and the relative humidity is 95%.
Wind Scooper
Installation Site
Fan
The repeater can be installed in a rack, bracket, and cabinet,
Control Panel
or on a desk.
Float Charging Board
Pre-installation Tasks
Preparing the Tools
●
Phillips screwdriver
●
T-10 torx screwdriver
●
Spanner
●
Anti-static gloves
●
Multimeter
Checking the Power Supply
Before you install the repeater, make sure that the power
supply meets the following requirements:
DC power voltage: 13.6±15% V
●
Part Name
No.
Part Name
5
Wind Scooper
6
Fan
7
Control Panel
8
Float Charging Board
NOTE
Fo r m o r e i n fo r m a t io n , r efe r t o t h e S a fe t y
Information Booklet.
●
AC power voltage: 100–240 V
Installation Procedure
To install the repeater, do as follows:
1.
Wear the anti-static gloves.
2.
Place the repeater to a proper location.
NOTE
If the repeater is installed in outdoor environments
with frequent thunderstorms, such as the top
of mountains or buildings, you must install an
external lightning protection module (optional) on
the network interface.
3.
Connect the antenna, feed line, power cord and ground
cable to the repeater.
NOTE
You must purchase the antenna and feed lines
●
separately.
You must prepare a ground cable.
●
4.
Ground the repeater through the ground screw located
on the rear panel.
Post-installation Check
To check whether the repeater works properly, do as follows:
1.
Turn the repeater on.
2.
Observe the LED indicators and the display in the front
panel.
●
If the repeater works properly, the power supply
indicator on the float charging board glows yellow
or blue, and the display shows the current channel.
If not, the power supply indicator glows red, and
●
the display shows the alarm code.
NOTE
For details, see Checking the Status.
2
Advertisement
