Moons' 3SR8-Plus Quick Setup Manual

Moons' 3SR8-Plus Quick Setup Manual

Step motor drive

Advertisement

3SR8-Plus
Step Motor Drive

Requirements

To use the 3SR8-Plus Step Drive, the following items are
needed:
• A power supply (24 - 75 VDC)
• Pulse & Direction signal
• A compatible step motor
Control signal
Switches for

Connecting to a Motor

Never connect the motor to or disconnect it from the drive when the power is on. Never connect the motor
leads to ground or to a power supply.
A 3-phase step motor's winding is either a star or delta confi guration. The 3SR8-Plus drives and MOONS'
motors are set up for delta connection. Connect the motor leads to the drive screw terminals U, V, and W.
Any two leads may also be reversed to change the motor's running
consult the documentation for that motor.

Selecting the Motor

Each position of the 16-bit rotary switch selects a different motor, and automatically sets the confi guration
parameters in the drive. The 3SR8-Plus drive comes programmed with up to 5 typical motors as factory de-
faults. Drives can be customized with specially selected motors when required. Available options are on the
drive label.
The switch also selects a low or high inertia for each motor to allow for various load conditions.
The low setting is 1:1, and the high setting is 10:1. Each motor in the loaded database has
unique settings to optimize the anti-resonance.
If the motor selection is changed, the drive power supply will need to be cycled.
1
LED
OUT-
OUT+
EN-
EN+
DIR-
DIR+
STEP-
STEP+
SW8
SW7
SW6
selecting
Switches for
SW5
SW4
selecting
SW3
SW2
SW1
B-
Motor
B+
Connector
A-
A+
Power
V-
Connector
V+
Grounding
Screw
3
Quick Set-Up Guide

Connect to the Power Supply

If the power supply does not have a fuse
on the output or some kind of short circuit
current limiting device, a 4 amp fast acting
fuse should be installed in line with the "+"
power supply lead.
Connect the motor power supply "+" ter-
minal to the drive terminal labeled "V+".
Connect the power supply "-" to the drive
terminal labeled "V-".
Be careful not to reverse the wires.
SW12
SW11
SW10
SW9
4
2
direction. For a star confi guration,

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3SR8-Plus and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Moons' 3SR8-Plus

  • Page 1 A 3-phase step motor’s winding is either a star or delta confi guration. The 3SR8-Plus drives and MOONS’ motors are set up for delta connection. Connect the motor leads to the drive screw terminals U, V, and W.
  • Page 2 Selection Switches Many operational parameters of the Running current Idle current Microstepping 3SR8-Plus can be set or changed by posi- SW10 SW11 SW12 tion switches - either by a single switch or Self test Step Smoothing Filter Load Inertia Step Noise Filter...

Table of Contents