Table of Contents
Advertisement
Do not use gasoline, paint thinner,
mineral spirits, etc. These may damage
painted surfaces.
Cutterhead knives are
dangerously
Use extreme caution when cleaning.
4. Apply a thin layer of paste wax to the
bright surfaces of the fence and tables
to prevent rust.
Installing Bed to Stand
1. Use an assistant or hoist mechanism to
place bed assembly on top of stand.
Be sure identification label on the bed
faces the same direction as the label
on the stand (Fig. 1).
2. Line up two holes in top of stand with
holes in bed assembly by viewing
through access door in stand.
3. Attach bed assembly to stand with two
3/8" lock bolts and lock washers (Fig.
2). Hand tighten only at this time.
4. Line up third hole in stand with hole in
bed assembly by viewing through dust
chute.
5. Install third 3/8" lock bolt and lock
washer through dust chute to secure
bed to stand.
6. Tighten all three mounting bolts with
14mm wrench.
Installing Pedestal Switch (JWJ-
8HH only)
Referring to Figure 3:
1. The switch may be installed in either
high position or low position to suit the
operator. Slide the connection plug
through the opening (A) and secure the
pedestal switch using two 5/16"x3"
screws (C) and 5/16" flat washers (B).
2. Connect the plug from the pedestal
switch to the motor plug inside the
cabinet.
sharp!
8
Figure 1
Figure 2
Figure 3
Advertisement
Table of Contents
