Table of Contents
Advertisement
Installing Dust Chute
Attach the dust chute (Fig. 10) to the stand
with four screws and four flat washers,
through the pre-tapped holes in the stand.
Electrical Connections
Electrical connections
must be made by a qualified electrician
in compliance with all relevant codes.
This
machine
must
grounded to help prevent electrical
shock and possible fatal injury.
Model JWJ-8CS: Remove the cover of the
switch box (A, Fig. 11) and mount the box
to the right side of the stand using the two
screws provided. Insert the motor leads
through the hole in the stand as shown, and
insert a grommet (B, Fig. 11).
Consult the wiring diagram inside the
switch box cover. The diagram is also on
page 30 of this manual.
The JWJ-8CS and JWJ-8HH jointers are
rated at 230V, single phase only. Confirm
that the power at the source is compatible
with the jointer before inserting plug into the
outlet. The jointer is designed to be used
with a plug and outlet similar to that shown
in Fig. 12.
Important: Make certain the receptacle
in question is properly grounded. If you
are
not
sure,
have
electrician check the receptacle.
Extension Cords
Make sure the rating of the extension cord
is suitable for the amperage listed on the
machine's motor plate. An undersize cord
will cause a drop in line voltage resulting in
loss of power and overheating.
Use the chart in Figure 13 as a general
guide in choosing the correct size cord. If in
doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the
cord.
be
properly
a
registered
11
Figure 9
Figure 10
Figure 11
Figure 12
Advertisement
Table of Contents
