Table of Contents
Advertisement
Cutterhead
dangerously
extreme caution when cleaning.
4. Apply a thin layer of paste wax to the bright
surfaces of the fence and tables to prevent
rust.
Installing Bed to Stand
1. Use an assistant or hoist mechanism to
place bed assembly on top of stand.
sure identification label on the bed faces the
same direction as the label on the stand
(Fig. 1).
2. Line up two holes in top of stand with holes
in bed assembly by viewing through access
door in stand.
3. Attach bed assembly to stand with two 3/8"
lock bolts and lock washers (Fig. 2). Hand
tighten only at this time.
4. Line up third hole in stand with hole in bed
assembly by viewing through dust chute.
5. Install third 3/8" lock bolt and lock washer
through dust chute to secure bed to stand.
6. Tighten all three mounting bolts with 14mm
wrench.
Installing Pedestal Switch (JJ-8HH
only)
Referring to Figure 3:
1. The switch may be installed in either high
position or low position to suit the operator.
Slide the connection plug through the
opening (A) and secure the pedestal switch
using two 5/16"x3" screws (C) and 5/16" flat
washers (B).
2. Connect the plug from the pedestal switch
to the motor plug inside the cabinet.
knives
are
sharp!
Use
Be
8
Figure 1
Figure 2
Figure 3
Hide quick links:
Advertisement
Table of Contents
