Assembly; Attach Support To Planer; Install Dust Chute And Filter Bag; Install Fence And Bracket To Planer - Jet JJ-6HHBT Operating Instructions And Parts Manual

8.0 Assembly

For assembly convenience, the item letter
designators used throughout the Assembly
section are the same as those used to identify
shipping content and hardware.

8.1 Attach support to planer

Attach fence support (E, Figure 8-1) to planer
with two M6x16 socket head bolts, flat washers
and lock washers.
Insert locking plate assembly (H) into support.
Position plate so that pins are against bottom
edge of support.
Secure plate in position with fence sliding handle
and spacer (G, Figure 8-1).
Figure 8-1

8.2 Install dust chute and filter bag

Slide the dust chute onto the end of the chip
exhaust. Tighten the pan head screw. See
Figure 8-2.
Figure 8-2
Open the zipper on the bottom of the bag, place
the spring inside of the filter bag arm.
Slide the arm with the spring over the dust
exhaust port.
Close the zipper. See Figure 8-3.
8.3 Install fence and bracket to
planer
Attach fence (B, Figure 8-4) to fence bracket
assembly (D) with two M6x20 socket head bolts.
Slide fence and bracket over and onto dovetails
of support (E) and locking plate (H, Figure 8-1)
Continue to slide fence forward so that the fence
is over the planer tables. At this position the
edge of the blade guard will rest against the
fence, and the entire width of the cutter head is
covered. Secure bracket in position with fence
sliding handle (G, Figure 8-1).
Insert fence tilting handle with spacer (C, Figure
8-4) through right link and thread into left link.
See Figure 8-5:
Make sure limit plate (A, Figure 8-5) is resting in
slot of block (B). Position fence against shaft (D)
and lock fence in position with fence tilting
handle.
Place a combination square against face of
fence and table surface. The fence and table
must be at 90° to each other. If not, loosen tilting
handle (C, Figure 8-4), loosen hex nut (C, Figure
8-5) and turn shaft (D, Figure 8-5) with a screw
driver until fence is square. Secure in position by
tightening hex nut (C, Figure 8-5).
Use a bevel gauge or protractor to check 45°
inward and outward limit stops. The 45° inward
stop (E, Figure 8-5) is the hex head bolt located
beneath the shaft. The 45° outward stop is
located at the top of the fence.
8
Figure 8-3