Table of Contents
Advertisement
INSTALLATION
GENERAL
Your radio is supplied with a U-shaped mounting cradle. As the radio does not
contain a built-in speaker, the cradle can be screwed or bolted to any convenient
location in your vehicle's cabin (under or above the dash, on the centre console,
under or beside the seat, etc) using the mounting slots provided in the cradle.
When planning your installation, avoid locations that are close to heaters or air
conditioners.
The mounting cradle design supports a wide range of flexible mounting options.
The radio can be mounted above or below the cradle and the cradle can be
orientated with the arms extending either forwards or backwards to adjust the
position of the front panel with reference to the mounting point
INSTALLING THE CRADLE
Screw the mounting cradle to a firm surface then position the main unit in the
cradle. Orientate the holes in the chassis with those in the cradle arms then insert
and tighten the gimbal knobs. Finally, connect the power lead, antenna cable and
extension speaker to the sockets on the radio's rear panel.
66
XRS-330C
Advertisement
Table of Contents
