Installation
General
Your radio is supplied with a U-shaped mounting cradle. As the radio does not contain a built-in
speaker, the cradle can be screwed or bolted to any convenient location in your vehicle's cabin
(under or above the dash, on the centre console, under or beside the seat, etc) using the mounting
slots provided in the cradle.
When planning your installation, avoid locations that are close to heaters or air conditioners.
The mounting cradle design supports a wide range of flexible mounting options. The radio can be
mounted above or below the cradle and the cradle can be orientated with the arms extending either
forwards or backwards to adjust the position of the front panel with reference to the mounting point
Installing the cradle
Screw the mounting cradle to a firm surface then position the main unit in the cradle. Orientate the
holes in the chassis with those in the cradle arms then insert and tighten the gimbal knobs. Finally,
connect the power lead, antenna cable and extension speaker to the sockets on the radio's rear
panel.
Mounting the cradle
Option 1
Option 2
May 2019
© 2019 Standard Communications Pty Ltd. All rights reserved.
49289-3
XRS-330C Instruction Manual
52