Table of Contents
Advertisement
Resend the LAST SelCall number
Use the
or
keys to select
'Last', then HOLD MENU
[HLD:CALL] to resend the last
SelCall number.
Save the LAST SelCall number in
memory
Use the
or
keys to
select 'Last' and press MENU
[SEL:SAVE] to save the last
SelCall number into one of the
memories. 'Select Slot to Save' is
displayed.
Use the
or
keys to scroll
down to an empty SelCall memory
then press MENU [SEL:EDIT].
The 'Edit Contact' screen is
displayed and the SelCall number
is automatically inserted into the
contact.
To edit the contact name;
• Use the
or
keys to
change the character or the
cursor position.
• Press MENU [SEL:NEXT]
to step forward to the NEXT
character position or BACK
to step back to the previous
character position.
Continue until the required name
has been entered then HOLD
MENU [HLD:SAVE] to save the
contact.
Edit your radio's OWN SelCall
number
Use the
or
keys to select
'Own' then press MENU to edit
your radio's own SelCall number.
The 'Edit Contact' screen is
displayed and 'Own' is displayed
as the contact name with the
cursor on the SelCall number.
Use the
or
keys to change
the number or the cursor position.
Press MENU [SEL:NEXT] to step
forward to the NEXT digit position
or BACK to step back to the
previous digit position.
Continue until the required name
has been entered, then HOLD
MENU [HLD:SAVE] to save the
new number.
Add a NEW contact to the
SelCall Memory
Use the
or
keys to scroll
to an empty SelCall memory then
press MENU [SEL:EDIT] to edit
BACK TO CONTENTS
Use the
or
keys to change
the letter or number at the cursor
position.
Press MENU [SEL:NEXT] to step
forward to the NEXT character
or digit position or the BACK
key to step back to the previous
character or digit position.
Continue until the required
name and SelCall number has
been entered then HOLD MENU
[HLD:SAVE] to save the new
number.
The radio returns to the previous
screen and displays the new
contact entry.
INSTALLATION
General
Your radio is supplied with a U-shaped mounting cradle. As
the radio does not contain a built-in speaker, the cradle can be
screwed or bolted to any convenient location in your vehicle's
cabin (under or above the dash, on the centre console, under or
beside the seat, etc) using the mounting slots provided in the
cradle.
When planning your installation, avoid locations that are close to
heaters or air conditioners.
Installation
The mounting cradle design supports a wide range of flexible
mounting options. The radio can be mounted above or below the
cradle and the cradle can be orientated with the arms extending
either forwards or backwards to adjust the position of the front
panel with reference to the mounting point
Installing the cradle
Screw the mounting cradle to a firm surface then position the
main unit in the cradle. Orientate the holes in the chassis with
those in the cradle arms then insert and tighten the gimbal knobs.
Finally, connect the power lead, antenna cable and extension
speaker to the sockets on the radio's rear panel.
Mounting the cradle
Option 1
Option 2
PAGE 14
Advertisement
Table of Contents
