Table of Contents
Advertisement
Close the battery cover. Make sure the gasket (around the battery
compartment) is properly seated in its place prior to closing the door.
Tighten the set screw.
Note: Do not install the batteries backwards. You can permanently
damage the sensors. The solar panel does not charge the batteries, so
rechargeable batteries are not needed or recommended.
Note: We recommend installing Lithium AA batteries for sensors.
The sensor LED indicator will light for 3 seconds, and then flash once
per 16 seconds thereafter. Each time it flashes, the sensor is
transmitting data.
Place the battery cover and push it to close the compartment.
Note: If the sensor does not power up after inserting the batteries,
press the reset button shown in Figure 6.
3.4 Display Console
3.4.1 Display Console Layout
The display console layout is shown in Figure 7
Note: The following illustration shows the full segment LCD display
for description purposes only and will not appear like this during normal
operation.
Figure 6
6
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WS-0835 and is the answer not in the manual?