Table of Contents
Advertisement
Integrated Outdoor
Transmitter
1
Dimensions (LxHxW)：
13 x 6 x 11in
Foot Mounting (with pole
1
insert)
Dimensions: 3 x 4 x 1 ½"
Mounting Bracket Back Plate
(pole mount)
1
Dimensions:3 x 3 x 1 "
Mounting Pole
1
Dimensions: 12 x 1½ x 1"
Pole mounting nuts (M3) /
2
bolts Ø3)
Pole mounting nuts (M5) /
4
bolts ( Ø5)
2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WS-0835 and is the answer not in the manual?
Questions and answers
My unit will not display outdoors Temperature's at all
The Sainlogic WS-0835 may not be displaying outdoor temperatures due to the following reasons:
1. Sensor Connection Issue – The integrated outdoor transmitter may not be properly connected to the display console. Ensure the transmitter is powered on and within range.
2. Battery Issue – The outdoor sensor may have weak or dead batteries. Replace them with a fresh set.
3. Interference – Wireless interference from other electronic devices may be disrupting the signal. Move the console and sensor away from potential sources of interference.
4. Calibration Problem – The sensor may need calibration. Use the calibration feature to match the outdoor temperature with a known source.
5. Physical Obstruction – Ensure there are no obstacles blocking the signal between the sensor and the console.
6. Defective Sensor – If none of the above solutions work, the outdoor sensor may be faulty and require replacement.
This answer is automatically generated
whats the benefit of pay for the app
How do you get the unit to measure ambient temperature not feels like temperature
The Sainlogic WS-0835 automatically displays the outdoor (ambient) temperature as the "OUT" temperature when it is between 40°F and 80°F, and in this case, the "Feels Like" temperature is the same as the "OUT" temperature. There is no instruction in the provided context on how to manually switch between ambient and "Feels Like" temperature measurements.
This answer is automatically generated
I cannot get the rain collector funnel off to clean it. It turns but I don’t think it is 30 degrees and of course, I’m worried about breaking it. Any suggestions.
To safely remove the rain collector funnel from the Sainlogic WS-0835 for cleaning:
1. Unscrew the rain collector funnel by turning it 30° counterclockwise.
2. Gently remove the rain collector funnel.
After cleaning and drying, reinstall the funnel.
This answer is automatically generated