Table of Contents
Advertisement
important to test all components for correct function before placing and mounting
them at their final destinations (See Positioning below)
1.
Unwind the cables for the Rain and the Wind sensors. Connect the Rain and
the Wind sensors to the Thermo-hygro transmitter by plugging the connector
heads of the two sensors into the appropriate sockets of the Thermo-hygro
transmitter.
2.
First insert the batteries into the Thermo-hygro transmitter (see "How to install
and replace the batteries into the Thermo-hygro transmitter"below).
3.
Then insert the batteries into the Weather Centre (see "How to install and
replace the batteries into the Weather Centre" below). Once the batteries
are installed, all segments of the LCD will light up briefly and a short signal
tone will be heard. It will then display the time as 12:00, the date as 1.1.05, the
weather icons, and air pressure value. "- - -" will be shown for outdoor data.
Sockets for wind
and rain sensor
7
Advertisement
Table of Contents
