Troubleshooting - Electrolux OKF5C70X User Manual

30 www.electrolux.com
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
One of the hinge-arms
(normally the right one) is
free to move. Make sure,
that both hinge-arms are in
the same position
(approximately 70° angle).
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate or op‐
erate the oven. The display
shows "400" and an acous‐
tic signal sounds.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
11.5 Replacing the lamp
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
The top lamp
1. Turn the lamp glass cover to remove
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
4. Install the glass cover.
Possible cause
The oven is incorrectly
connected to an electrical
supply.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
WARNING!
Risk of electric shock.
The lamp can be hot.
cavity.
it.
°C heat-resistant lamp.
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.