Delta Electronics VFD-M Series User Manual page 42

Parameter Explanation
Electronic Thermal
Pr.59
Motor Overload
Over-Torque
Pr.60
Detection Mode
Over-Torque
Pr.61
Detection Level
Over-Torque
Pr.62
Detection Time
Loss of ACI
Pr.63
(4-20mA)
User Defined Function
Pr.64
for Display
Pr.65 Coefficient K
Communication
Pr.66
Frequency
Pr.67 Skip Frequency 1
Pr.68 Skip Frequency 2
Pr.69 Skip Frequency 3
Pr.70 Skip Frequency Band 0.00 to 20.00 Hz
Revision May 2008, ME14, SW V3.04
Settings
30 to 300 sec
00: Over-Torque Detection Disable
01: Enabled during constant speed operation
until the allowable time for detection
(Pr.62) elapses.
02: Enabled during constant speed operation
and halted after detection.
03: Enabled during acceleration until the
allowable time for detection (Pr.62)
elapses.
04: Enabled during acceleration and halted
after detection.
30 to 200 %
0.0 to 10.0 seconds
00: Decelerate to 0 Hz
01: Stop immediately and display "EF"
02: Continue operation by last frequency
command
00: Display AC drive output Frequency (Hz)
01: Display User-defined output Frequency
(H*Pr.65)
02: Output Voltage (E)
03: DC Bus Voltage (u)
04: PV (i)
05: Display the value of internal counter (c)
06: Display the setting frequency (F or o=%)
07: Display the parameter setting (Pr.00)
08: Reserved
09: Output Current (A)
10: Display program operation (0.xxx), Fwd,
or Rev
0.01 to 160.0
0.00 to 400.0 Hz
0.00 to 400.0 Hz
0.00 to 400.0 Hz
0.00 to 400.0 Hz
Chapter 4 Parameters|
Factory
Setting
60
00
150
0.1
00
06
1.00
0.00
0.00
0.00
0.00
0.00
Customer
4-7