Scheduling - Pure Clean PUCRC95 User Manual

PRODUCT OPERATION

SCHEDULING

You can schedule the robot to make it start cleaning automatically at a
certain time everyday.
1. The robot can only be set when it's in standby or charging on the docking
station. (If the robot is in cleaning, pause it before scheduling. If the robot
is in sleep mode, long press CLEAN button on main body or ON/OFF on
remote controller to wake it up. If the robot is in deep sleep-power o ,
long press CLEAN button on main body to wake it up.)
2. Before scheduling, please set the real time for remote: Long press CLK
button on remote for 3 seconds to enter hour-setting,
and the left two numbers will ash on remote display, press upward /
downward button to increase or decrease hour. Press left button can turn
to minute-setting, the right two numbers will ash on remote display,
press upward / downward button to increase or decrease minutes.
Continue to press left button, will enter into week day setting,from SUN.
To SAT. At last, press CLK once to con rm the real time setting,
on.
3. How to schedule: After real time setting, point the remote controller to
the robot signal receiver (robot must be in standby or charging on the
docking station, long press PLAN button on remote for 3 seconds to enter
hour- scheduling setting, the left two numbers will ash on remote display,
press upward / downward button to increase or decrease hour(0-23). Press
left button can turn to minute-scheduling setting, the right two numbers
will ash on remote display, press upward / downward button to increase
or cancel every half an hour. Press ON/OFF button on remote to con rm
the scheduling,
indicator on robot will stay pink for 2 seconds and beep once, means
robot is successfully scheduled.
4. How to cancel scheduling: Point the remote controller to the robot signal
receiver(robot must be in standby or charging on the docking station),
long press PLAN button on remote for 3 seconds to enter hour- scheduling
setting, set the time to 00:00, press ON/OFF button on remote to con rm
the canceling. The
pink for 2 seconds and beep twice, means robot scheduling has been
canceled successfully. You can long press PLAN button on remote to
revert to main panel.
5. When robot is in standby or charging on the docking station, points the
remote controller to the robot signal receiver, user can short press PLAN
button to check whether robot has already scheduled. If yes, there is an
icon and a scheduling time display on remote, CLEAN indicator on robot
will stay pink for 2 seconds and beep once. If not, there is 00:00 on remote
display only, CLEAN indicator will have no change but robot beeps twice.
10
www.PyleUSA.com
icon will stay on the remote display, and the CLEAN
icon will disappear, CLEAN indicator on robot ash
icon will ash,
icon stays