Hornbach JWS1100X Manual page 105

1 INSTALL WHEEL
THICKNESS: < 4 MM
Install straight grinding wheels with the
lock nut 4 so that the flange points away
from the machine.
Press and hold the spindle lock button 2
and tighten the lock nut 4 with the wrench.
1 ADJUST GUARD
Pull up the grinding guard 9 at it's very
end until it disengages from the guard
lock latch 3.
Warning! Make sure the tool is
switched off and unplugged.
1 CHANGE GUARD
Remove the cutting wheel and the lower
flange 10.
Warning! Make sure the tool is
switched off and unplugged.
3
Remove the grinding guard 9 from the
tool.
2
THICKNESS: ≥ 4 MM
Install depressed grinding wheels with
the lock nut 4 so that the flange points
towards the machine.
Press and hold the spindle lock button 2
and tighten the lock nut 4 with the wrench.
2
Rotate the grinding guard 9 into the de-
sired position. Make sure that the guard
lock latch 3 is engaged.
Warning! The guard shall be oriented
to protect the auxiliary handle.
2
Remove the 3 screws from the guard lock
latch 3, by use of a 3 mm allen wrench.
4
Install the cutting guard (accessory) by
use of the guard lock latch 3 and the three
screws.
Reinstall the lower flange 10 and install a
cutting wheel.
EN 105