Product Overview; Intended Use; Using The Tool; Restart Protection - Hornbach JWS1100X Manual

Product Overview

1 Auxiliary handle
2 Spindle lock button
3 Guard lock latch
4
Lock nut
5
Supply cord
6
Main handle
7 On / Off switch
8 Auxiliary handle connector
9 Grinding guard
10 Lower flange

Intended Use

The tool is intended for roughing and grinding of
metal and stone materials without the use of wa-
ter when equipped with a suitable grinding disc
and the appropriate guard.
For cutting the material mentioned above, a spe-
cial cutting guard (accessory) must be installed.
Any other use or modification to the tool is consid-
ered as improper use and could cause consider-
able dangers.
1 AUXILIARY HANDLE
The auxiliary handle can be attached to
the auxiliary handle connector 8 on either
side of the tool.
Warning! Make sure the tool is
switched off and unplugged.
104 EN

Using the Tool

1. Fit an appropriate wheel.
2. Make sure your workpiece can not slip and
hold the tool firmly at the main handle 6.
3. To switch on the tool, push and then press
the on / off switch 7.
4. Let the tool run at no-load speed for
about a minute and check if the in-
stalled wheel runs flawlessly.
Grinding:
The best grinding results can be
achieved with a 30° to 40° ap-
proach angle. Move the tool back and
forth with moderate pressure.
5. To switch off the tool, release the on / off
switch 7.

Restart Protection

The restart protection prevents the uncontrolled
start-up of the tool after an interruption of the
power supply.
To restart, set the on / off switch 7 to the off posi-
tion and turn the tool on again.
2
Screw the auxiliary handle into the auxil-
iary handle connector 8.
Warning! For safe working conditions,
make sure the auxiliary handle is al-
ways mounted at the tool.