Hornbach JWS1100X Manual page 102

c) When wheel is binding or when interrupting
a cut for any reason, switch off the power
tool and hold the power tool motionless
until the wheel comes to a complete stop.
Never attempt to remove the cut-off wheel
from the cut while the wheel is in motion
otherwise kickback may occur. Investigate
and take corrective action to eliminate the
cause of wheel binding.
d) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel
may bind, walk up or kickback if the power tool
is restarted in the workpiece.
e) Support panels or any oversized workpiece
to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under
their own weight. Supports must be placed un-
der the workpiece near the line of cut and near
the edge of the workpiece on both sides of the
wheel.
f) Use extra caution when making a "pocket
cut" into existing walls or other blind ar-
eas. The protruding wheel may cut gas or wa-
ter pipes, electrical wiring or objects that can
cause kickback.
ADDITIONAL SAFETY INSTRUCTIONS ON RISKS
DUE TO VIBRATION
a) The declared vibration data represents the
main applications of the tool, but different
uses of the tool or poor maintenance can
result in different vibration data. This may
significantly increase the vibration level over
the total working period.
b) Additional safety measure shall be taken to
protect the user from effects of vibration.
Maintain the tool and its accessories, keep
hands warm and organize work patterns and
periods.
102 EN