Old Style Clearchart Wall Mount Bracket; Installing The Clearchart Wall Mount Bracket - Ametek Reichert Clearchart 4 User Manual

Installation, Features, & Functions

Old Style ClearChart Wall Mount Bracket

If the old style ClearChart Wall Mount Bracket is preferred, or if it is already installed on the wall, the
optional Wall Mount Bracket Adaptor (P/N 13775-014) can be used to mount the new ClearChart 4 to
the older ClearChart Wall Mount Bracket.
Line up the metal plate so that the tabs are oriented up, and the screw holes line up with the
ClearChart 4 screw holes. Secure the plate with the 4 Thumb Screws. Refer to Figure SU-15.

Installing the ClearChart Wall Mount Bracket

1. Find an appropriate spot on the wall that will support the ClearChart 4, which will hang from the
Wall Mount Bracket attached to the wall inserts included with the accessories. Ensure that the
refraction distance meets the requirements for either Direct-throw or Mirror Arrangement.
2. Level the supplied Wall Mount Bracket (P/N 13750-008) with the metal tabs facing up and out on
your wall and mark the holes on the wall.
3. Using the supplied Drywall Fasteners, place the tip of each fastener on the marked hole and using a
hammer tap the insert into the wall as far as the threads on the insert. Using a phillips-head screw-
driver, screw the fastener into the wall until the surface is flush with the wall. Refer to Figure SU-16.
CAUTION: DO NOT OVER DRIVE THE INSERTS INTO THE WALL.
4. Place the Wall Mount Bracket on the wall, and screw the supplied screws into the Drywall Fasteners.
Refer to Figure SU-17.
5. Hang the ClearChart 4 by lining-up the holes on the back of the adaptor plate with the metal tabs of
the Wall Mount Bracket and hang the unit from these tabs.
Figure SU-16 Drywall Fastener
13795-101 Rev. J
Screw
Holes
Figure SU-15 Align Holes and Attach
(continued)
Attach
Plate
Figure SU-17 Mounting the Wall Bracket
15