Hyperterminal Setup - Cirrus Logic EDB9315A Technical Reference Manual

HyperTerminal Setup

Run the HyperTerminal program and configure to use COM1 and to run at 57600 baud, 8 data
bits, no parity, one (1) stop bit (8-N-1) and NO hardware control flow. It should look like the
picture below when complete. Note you have to "Disconnect" in order to make configuration
changes. Click "Call" once the configuration is complete.
DS638DB3
©
Copyright 2006 Cirrus Logic, Inc.
EDB9315A
Technical Reference Manual
37