Clean Out Of The Box, No Need For Cleaning Prior To Initial Use - Whirlpool 8LIECH-BP-WL User Manual

CLEAN OUT OF THE BOX,
NO NEED FOR CLEANING PRIOR TO INITIAL USE
Your water cooler is Clean Out of The Box. Cleaning described below is not required. However if
you choose to clean your water cooler for any reason, please follow the instructions below.
Time Required: 30 minutes.
Notice: Unplug the power cord.
1. Remove the air filter and wash it in soapy water.
2. Submerge the probe head in the soapy water and rinse properly.
3. Spray the dispensing nozzles of water faucets with chlorine solution (one teaspoon of
unscented bleach composition (I.E.5.25% sodium hypochlorite) in one glass of water).
4. Reattach air filter of the probe assembly.
5. Fill bottle with chlorine solution ( 60 ml of unscented bleach) per 3 liters of water) and activate
the pump. Allow chlorine solution to wash probe inside. Shut off after 3 liters of solution is
pumped through.
6. Place a 2 gallon or larger bucket under the drain plug in the rear of the cooler.
7. Once the unit has been drained, replace the drain plug and drain cap.
8. Remove the remaining water from the reservoirs by dispensing it from the cold tap into a
pitcher.
Rinsing
9. Fill bottle with 2 gallons of tap water.
10. Insert probe assembly, place bottle into water cooler and close the door.
11. Allow cooler to be filled with water.
12. Drain water out as in steps 6, 7 and 8.
13. If chlorine taste persists repeat rinsing procedure or leave it sit for a few days and chlorine
taste will disappear.
14. You may use a 10% vinegar solution instead of chlorine solution.
15. Complete the installation and follow the operation instructions indicated in this manual. If your
water has an off taste do not return the cooler to the store, call 1-855-594-4755 for assistance.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-BP-WL: Page 7