Setting The Alarm Time; Setting The Alarm Station - Tecsun PL-368 Manual

Setting the Alarm Time

1) Press and hold [ ALARM ] until the alarm time in the upper right corner
of the display starts flashing.
2) While still flashing, use the numeric keys to enter the time (4 digits in
total), or rotate the [ TUNING ] knob to adjust the hour and the
[ VOLUME ] knob to adjust the minutes, and then press [ ALARM ] to
confirm. The display then automatically shows the duration of the alarm
while " " and "
3) Turn the [ TUNING ] knob to set the duration of the alarm (01 - 60
minutes).
4) Quick press [ ALARM ] to confirm the setting. The alarm "
shown on the display.

Setting the Alarm Station

1) Select the station frequency you want to use as the alarm.
2) Quick press [ M ], the preset memory location will flash.
3) While still flashing, quick press [ ALARM ], the alarm "
flash.
4) While still flashing, quick press [
and the setting is complete.
Tips:
If the device is turned off with a volume level below 10, then upon
reaching the alarm time, the device turns on at the default volume level
of 10.
Once the preset alarm time is reached, the radio turns on and stays on
for as long as the alarm duration (01 – 60 minutes) was set. To turn off
the device during the alarm playtime, quick press the [ POWER ] button
twice.
During the alarm playtime, quick press [ POWER ]. This will deactivate
the alarm, after which you can change to a different frequency.
If the device is not used for 3 days, the alarm deactivates automatically.
" flash on the display.
] to confirm, "
21
" icon is
" icon will
" stops flashing