SPECIFICATIONS PL-310 Functional Block Diagram PL-310 is using DSP si4734 Microchips (from Silicon Labs in 1. Frequency range USA) to digitalize the analog AM/FM broadcasting signal base 87~108 MHz on the modern software technology and radio principles. It can highly improve on radio's sensitivity, selectivity, S/N ratio and Russia 64~108MHz anti-interference.
TABLE OF CONTENTS MEMO CONTROL LOCATIONS........... 2 LCD DISPLAY..............4 QUICK START GUIDE............5 TURN THE RADIO ON OR OFF.........8 Manual tuning ● Auto scan stations ● Direct frequency entry ● LISTEN TO THE RADIO.............9 Manual tuning ● Auto scan stations ● Direct key-in frequency ●...
CONTROL LOCATIONS MEMO 13 14 Timer SLEEP TUNING FM & SW ANTENNA VOLUME DC-IN 5V...
Page 5
Power on/off Function Button Status Sound Display Display & Lock button " " in the display " " in the display Light / Snooze button MW (AM) or MW/LW B- - " " in the display Scan Mode button " "...
"Bi" SOUND VIA FUNCTIONS LCD DISPLAY Function Button Status Sound Display hour flashing Hour setting Timer minute flashing Time setting SLEEP TIME Minute setting Nothing flashing Temp. Confirm or Auto confirm hour flashing Hour setting minute flashing Minute setting 1~90 minutes display, Adjust the length are flashing of alarm...
QUICK START GUIDE TIME SETTING QUESTIONS ANSWERS SOLUTIONS 1. Long press [TIME] button until "hour" is flashing in the display. Rotate the [TUNING] knob to adjust the correct When the alarm -Did not set the -Preset your alarm "hour". activated (alarm proper radio station station properly 2.
Page 8
TROUBLE SHOOTING ATS( Auto Tuning Storage) on FM, MW, LW, SW band QUESTIONS ANSWERS SOLUTIONS 1. Turn on the radio, and fully extend the antenna. 2. Short press [FM] button to Select FM band. Can not turn on -no power with the -replace the new 3.
Page 9
IMPORTANT MATTERS FOR USING BATTERIES 1. If no battery has been installed inside for long time, clock DELETE MEMORY of radio would stop to work. However, pre-stored 1. Turn on the radio and press the [SCAN MODE] button, frequencies are still kept. Clock would work again after causing PRESET to appear in the display's upper right new batteries being re-installed inside.
1. Under radio being connected with external power sources, The battery compartment is located on the back of the PL-310. To remove the battery compartment cover, apply installing 3 x UM3 (AA) rechargeable batteries, press & thumb pressure and slide it towards the bottom of the...
LISTEN TO THE RADIO Short press [POWER] button to turn on your radio, and Turn LW on/off select your band by short press on [FM]、[MW/LW]、SW Turn off the radio. Press and hold the [MW/LW] button until ] or [ ] button. In case of receiving FM/ SW, telescopic "...
You can use it in MW, LW and SW band. There are total 500 preset memories within PL-310. For FM, MW, and LW, each band has 100 preset memories; and 200 preset memories for SW.
DISPLAY MODE Special note: OFF status: Short press [DISPLAY] 1. During ATS processing in FM, MW, LW and SW with button to view on Temperature, mode A, pre-stored radio stations would be deleted & Alarm time. covered automatically by the new searched stations. If Temp.
LISTEN TO STATIONS IN THE MEMORY PRESET Method 1: Manual memory search In case of alarm being activated during your listening of the radio, it will switch to the radio station which was set for 1. Short press the [SCAN MODE] Timer SLEEP alarm function.
DELETE MEMORY ALARM SETTING 1. Long press [ALARM] button with a "B" sound. Rotate Method 1: Delete memory manually the [TUNING] knob when "hour" is flashing in the display. 1. Short press the [SCAN MODE] 2. Short press [ALARM] button again with a "BB" sound, button with a "B"...
CLOCK SETTING The factory has set the clock to function as a 24-hour format Method 3: To delete all memories clock. If you prefer a 12 hour, AM/PM clock format, see the 1. Short press the [SCAN MODE] selection titled Changing the clock format. button with a "B"...
Need help?
Do you have a question about the PL-310 and is the answer not in the manual?
Questions and answers