Alarm Setting (By Radio Only) - Tecsun S-8800 Operation Manual

ALARM SETTING (by radio only)

20
1. Press and hold the [ALARM] button
on the radio until the hours indicator
starts blinking in the upper right corner
of the LCD. Rotate the [TUNING] knob
to adjust the hours. Then press the
[ALARM] button to confirm the hours
setting.
2. The minutes indicator starts blinking.
Rotate the [TUNING] knob to adjust
the minutes. Press the [ALARM]
button to confirm the minutes setting.
3. Now rotate the [TUNING] knob to set your desired "Alarm Off Timer" (1-90 minutes).
This is the duration after which the radio will turn off automatically. Press the
[ALARM] button to confirm the setting.
4. The alarm ON indicator "
deactivate the alarm, press the [ALARM] button and "
display.
How to preset the alarm station?
1. In radio ON mode, tune to your desired radio station and set an appropriate alarm
volume level.
2. Press the [MEMORY] button
the upper right corner of the LCD, quickly press the [ALARM] button
the alarm station. The alarm ON indicator "
has been set. To deactivate the alarm, press the [ALARM] button and "
disappears from the display.
Note:
When the alarm goes off, the upper right corner of the LCD shows the countdown of
minutes before the device turns off automatically (Alarm Off Timer).
How to stop the Alarm Off Timer?
To stop the Alarm Off Timer and enter normal radio listening mode, press the
[POWER] button on either the radio
button again to turn off the radio.
25
" on the LCD signifies that the alarm has been set. To
. While the stored station location "PXXX" blinks in
or remote control
Alarm ON symbol
Alarm Off Timer
" disappears from the
" on the LCD signifies that the alarm
. Press the [POWER]
hours minutes
Alarm time display
to confirm
"