Clock Setting; Alarm Setting - Tecsun S-2000 Owner's Manual

CLOCK SETTING

The TECSUN S-2000's clock is in 24-hour format and can be set with the radio on or off. When
the radio is turned off, the clock shows in mid-display. When the radio is turned on, the clock
shows in the upper right corner of the LCD display.
To set the clock:
Press the TIME button for about a second with a "B" sound until you see the hour flashing.
1. While it's flashing turn the TUNING knob to set it to the
correct hour, then press TIME again with a "BB" sound
to confirm and note that the minutes are flashing. Turn
the TUNING knob to set it to the correct minutes; then
press TIME with a long "B" sound to confirm.
2. Another way to set the clock is by direct enter hour and
minutes with numbers.
(For example, 14:50pm, just enter 1 4 5 0)
Note:
1. After setting the hour or minutes you can simply let the
flashing number time-out, without pressing the TIME
button to confirm the setting.
2. You can also use the
and minute instead of using the TUNING knob.

ALARM SETTING

There are two independently programmable alarm timers (TIMER A or TIMER B ON/OFF) to
turn it on and off at a specified time.
To set an alarm:
1. Turn off the radio and press the TIMER A or B ON/OFF
button with a "B" sound or until you see the alarm hour
flashing in the upper right corner of the display. While
it's flashing adjust the hour with the TUNING knob and
press the TIMER A or B ON/OFF button with a "BB"
sound and notice that the alarm minutes are flashing.
2. While it's flashing, adjust the alarm minutes with the
TUNING knob and press the TIMER A or B ON/OFF
button with another "BB" sound and notice the sleep
timer flashing in the box at the top of the display.
buttons to adjust the hour
/
14
flashing
The clock shows in the center
of the LCD when the radio is
off.
flashing
The clock shows in the upper
right corner of the LCD when
the radio is on.
flashing
flashing
SLEEP