Auto Tuning Storage (Ats) - Tecsun PL-368 Manual

Auto Tuning Storage (ATS)

Automatically tune into and store FM, LW, MW and SW stations
Operation for FM and MW/LW:
1) Quick press [ FM/ST. ] or [ MW/LW ] to select the frequency band.
2) Press and hold the [ FM/ST. ] or [ MW/LW ] button until "PRESET"
flashes and the frequency starts running.
3) When the frequency stops running, it means the ATS operation has
been completed. Rotate the [ TUNING ] knob to view all the stored
stations.
Operation for SW:
There are two ATS modes for SW:
Mode A: Press and hold the [ < ] button to initiate ATS within all meter
bands.
Mode B: Press and hold the [ > ] button to initiate ATS within the selected
meter band.
Tips:
ATS (except in SW mode B) replaces previously stored radio stations.
To prevent this from happening, please consider using ETM+ (see page
14).
ATS results for LW, MW and SW strongly depend on radio wave
propagation conditions, the receiving environment and other factors. If
the results are poor, try to initiate ATS at a different location and/or time,
or tune into stations manually and then store them.
For better ATS results in the LW, MW and SW bands, please also review
the tips for ETM+ on page 16.
11
.