Using Etm+ To Scan And Store Stations; Listening To Stations In The Etm+ Memory; Deleting A Single Etm+ Station - Tecsun PL-368 Manual

Using ETM+ to Scan and Store Stations

1) Quick press the [ ETM ] button, the display indicates "ETM".
2) Select the frequency band.
3) Press and hold the [ ETM ] button to start scanning for stations.
4) When scanning is complete, the display shows the number of
broadcast frequencies found (e.g.
If the ETM scan missed certain stations (e.g. due to interference), then it
is possible to add these to the ETM memory manually:
1) Quick press the [ ETM ] button, the display indicates "ETM" .
2) Select the frequency band.
3) Key in the frequency of the missing station using the numeric keypad.
4) Quick press the [ M ] button twice.
Note: For SW, ETM only scans/stores frequencies within the meter bands.

Listening to Stations in the ETM+ Memory

1) Quick press the [ ETM ] button, the display indicates "ETM".
2) Select the frequency band.
3) Rotate the [ TUNING ] knob to select a stored frequency.
Tip: To exit ETM mode, quick press the [ ETM ] or [ VF/VM ] button.

Deleting a Single ETM+ Station

1) Quick press the [ ETM ] button, the display indicates "ETM".
2) Select the frequency band.
3) Rotate the [ TUNING ] knob to select the frequency to be deleted.
4) Press and hold the [
"dEL".
5) Quick press the [
frequency.
Tip: To delete all ETM stations: review "Deleting All Stored Stations"
(page 14).
] (DEL.) button until the display shows
] button to confirm and delete the selected
17
).