To Store Station; Ats (Auto Tuning Storage) On Fm, Mw, Lw Or Sw Band; Manual Memory Search; Direct Key In The Station Address Number - Tecsun PL-310 Operation Manual

Method 4: Manual memory search (see page 12 )
Method 5: Auto-scan memory (see page12)
Method 6:

Direct key in the station address number

page 12)

TO STORE STATION

There are total 500 preset memories within PL-310. For
FM, MW, and LW, each band has 100 preset memories;
and 200 preset memories for SW.

ATS (Auto Tuning Storage) on FM, MW, LW or SW band

1) ATS (Auto Tuning Storage) on FM
1. Turn on the radio, and fully extend the antenna.
2. Short press [FM] button to select FM band.
3. Long press on [FM] button with a "B" sound and
frequency is running on the display. All the available
stations will be stored in the memory automatically. After
the long "B--" sound to be heard, ATS is completed and
is in the status of memory address.
4. Then use the [TUNING] knob to tune around for those
stored stations.
MW, LW or SW ATS is as same as the FM ATS.
2) ATS (Auto Tuning Storage) on MW or LW
1. Press & release [MW/LW] button to select MW or LW.
2. Press & hold [MW/LW] button and followed a "B" sound
and ATS starts to scan the radio stations in MW or LW.
3)ATS (Auto Tuning Storage) on SW
1. Fully extended the antenna, then press and release SW
[ ] or [ ] button to select SW.
2. There are mode A & mode B in SW.
Mode A: press & hold [ ] button to scan all radio stations
within all meter bands.
Mode B: press & hold [ ] button to scan all radio stations
in present meter band only.
10
AM BW (BANDWIDTH) BUTTON
(see
Short press [AM BW] button to choose 6, 4, 3, 2, 1 kHz
bandwidth. This may help to reduce interference on some
frequencies. Using WIDE usually results in better audio
fidelity, while using narrow limits the audio fidelity somewhat.
You can use it in MW, LW and SW band.
SYSTEM SETTING
Frequency range setting for FM
Turn off the radio, long press [FM SET] button, until 87.5-
108MHz, 64-108MHz, 76-108MHz, or 87-108MHz appears
in the display. Quickly keep pressing on the [FM SET]
button to select suitable frequency range for your local FM.
Changing the clock format
Turn off the radio, long press [12/24] button, until "
" " appears in the display. If "
display, which means the clock system will be in the 12 hour
format.
MW(AM) step setting
Turn off the radio, long press [9/10kHz] button until "9kHz"
or "10kHz" appears in the display. By long pressing again,
the alternative band step would be shown. The temperature
is also shown on screen at the same time.
In general practice, the 10kHz is to be used for broadcasting
MW(AM) as well as the temperature in the degree of
Fahrenheit (
In order to provide convenience to the end users, the
"10kHz" is default to be displayed with temperature in the
degree of Fahrenheit (
with temperature in the degree of Centigrade (
If the display shows "10kHz" with degree of Fahrenheit (
which means this radio is set to 10 kHz step for MW(AM)
with temperature in Fahrenheit (
" appears in the
) for the North America region.
) and for "9kHz" to be displayed
).
19
"or
) together.
),