Table of Contents
Advertisement
1.5
Equipment Description
FilterQuick™ FQG30 Series high-efficiency gas fryers employ a unique infrared burner system that
uses up to 43% less energy to cook the same volume as conventional open-burner fryers. Models in
this series include FQG variants. These models have a built-in FilterQuick™ fingertip filtration
system located under the leftmost fryer in a battery.
All FilterQuick™ FQG30 Series Gas fryers are of an open-frypot design with no tubes and have a
hand-sized opening into the cold zone, which makes cleaning the stainless frypot quick and easy.
Heating is supplied by a pair of infrared burner assemblies mounted on each side of the frypot.
Combustion air for the burners is supplied by a dedicated blower mounted on the front of the frypot.
FilterQuick™ FQG30 Series Gas fryers can be configured for natural gas, propane (LP), or
manufactured gas, as required by the customer.
Each frypot is equipped with a temperature probe for precise temperature control.
All FilterQuick™ FQG30 Series Gas fryers come standard with electronic ignition and melt cycle
mode. The FilterQuick™ FQG30 Series Gas fryers are controlled with a FilterQuick™ controller.
Fryers in this series come in full or split pot arrangements, and can be purchased as two, three or
four vat fryers.
All fryers in this series require an external source of AC electrical power. Units can be configured
for voltages ranging from 100 VAC to 240 VAC.
FilterQuick™ FQG30 Series fryers are shipped completely assembled. All fryers are shipped with a
package of standard accessories. Each fryer is adjusted, tested, and inspected at the factory before
crating for shipment.
1.6
Installation, Operating, and Service Personnel
Operating information for Frymaster equipment has been prepared for use by qualified and/or
authorized personnel only, as defined in Section 1.7. All installation and service on Frymaster
equipment must be performed by qualified, certified, licensed, and/or authorized installation
or service personnel, as defined in Section 1.7.
1.7
Definitions
QUALIFIED AND/OR AUTHORIZED OPERATING PERSONNEL
Qualified/authorized operating personnel are those who have carefully read the information in this
manual and have familiarized themselves with the equipment functions, or who have had previous
experience with the operation of the equipment covered in this manual.
1-3
Advertisement
Table of Contents
Troubleshooting
